Table of Contents
Advertisement
Maintenance Instructions
Lubrication
Mower Deck Spindle Lubrication
For mower decks with belt-driven blades, lubricate
each deck spindle grease fitting every 25 hours.
Use SAE general purpose lithium or molybdenum
base grease for grease fittings.
DR52, DS61 or DR64 Mower Deck Lubri-
cation
Lubricate the U-Joint in the PTO drive shaft every
25 hours with SAE general purpose lithium or
molybdenum base grease.
Check Transaxle Fluid Level
●
The transaxle oil lubrication is SAE 20W-50
(API Service Class SL or higher) engine oil.
●
Inspect both transaxle cases and hoses after
every 25 hours of operation for visible leaks.
●
The fluid level of the transaxles can be
checked visually by looking at the fluid level in
the expansion reservoir. When the transaxles
are cold, the fluid level in the expansion reser-
voir should be between 1/4 in. and 1/2 in. (6-13
mm) from the bottom, near the Cold Level line.
Hot Level
Cold Level
Expansion Reservoir Location
52
Reservoir Cap
Hose to
Transaxles
Transaxle Oil and Filter Change
Change the transaxle oil after the initial break-in
period of 75-100 hours. Thereafter, change oil
every 400 hours of operation as follows:
1.
Thoroughly clean the exterior of the transaxle
housing before servicing. Remove expansion
reservoir cap to allow venting. Using a 1/4 in.
hex wrench, remove the plug on the lower
inside of each transaxle allowing the oil to
drain.
2.
Remove the oil filter guard, remove and re-
place the oil filter using an oil filter wrench.
Tighten filter by turning filter 3/4 to 1 turn after
gasket contacts the filter base surface. Rein-
stall the oil filter guard. (Refer to Transaxle
Oil Drain Plug, Filter, and Guard Location
illustration.)
Oil Filter
Oil Filter
Guard
Transaxle Oil Drain Plug, Filter, and
Guard Location
(Shown with Deck Support Arms
Removed for Clarity)
3.
Reinstall drain plugs.
4.
Remove the oil reservoir hose attached to the
elbow on top of the transaxles. Remove the
elbows to access the oil fill opening.
5.
Fill the transaxles with 20W-50 (API Service
Class SL or higher) oil through the opening
(where the elbows were). Fill up to the open-
ing.
6.
Before reinstalling the elbows, screw the lock-
ing nut on the elbows down until they are snug
(the o-ring on the elbow will be to the bottom
of the o-ring groove).
H24d
Oil Drain
Plug
Advertisement
Table of Contents
