Triumph Street Triple S 2022 Owner's Handbook Manual page 43

Hazard Warning Lights
To turn the hazard warning lights on or
off, press and release the hazard
warning light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched OFF, until the
hazard warning light switch is pressed
again.
High Beam Light
When the ignition is switched
ON and the headlight dimmer switch is
set to HIGH BEAM, the high beam
warning light will illuminate.
Daytime Running Lights (DRL) (if
equipped)
When the ignition is switched
ON and the daytime running lights
switch is set to Daytime Running Lights,
the daytime running lights warning light
will illuminate. During daylight hours, the
Daytime Running Lights (DRL) improve
the visibility of the motorcycle to other
road users. Low beam headlights must
be used in any other conditions unless
the road conditions allow for high beam
headlights to be used.
The daytime running lights and low
beam headlights are operated manually
using a switch on the left hand switch
housing, see page 43.
GENERAL INFORMATION
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the Daytime Running
Lights when dark, in tunnels or where
poor ambient light is apparent may
reduce the riders vision or blind other
road users.
Blinding other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control
and an accident.
Low Fuel Warning Light
The low fuel indicator will
illuminate when there are approximately
1.19 gallon (4.5 liters) of fuel remaining in
the tank.
43