Fitting the ProLine element
Feed the mains connection cable
down through the cut-out.
Starting at the front, position the
ProLine appliance in the worktop cut-
out.
Using both hands, press down evenly
on the sides of the ProLine element
until it clicks into position. When
doing this make sure that the seal of
the appliance sits flush with the
worktop on all sides. This is
important to ensure an effective seal
all round.
Do not use any additional sealant
(e.g. silicone) on the ProLine
element.
If the seal does not meet the worktop
correctly on the corners, the corner
radius (≤ R4) can be carefully scribed
to suit.
Installing several ProLine elements
Push the built-in ProLine element to
the side until the holes in the spacer
bar can be seen.
Fit cover strip into the holes in
spacer bar .
Starting at the front, position the next
ProLine element in the worktop cut-
out.
Proceed as described previously.
Installation
43