Installation - Miele ProLine CS 1013-1 Operating And Installation Instructions

Installation

Preparing the worktop
 Make the worktop cut-out as shown
in "Building-in dimensions" or as
calculated (see "Installing several
ProLine elements" in the "Installation"
chapter). Remember to maintain the
minimum safety distances (see
"Installation – Safety distances").
Wooden worktops
 Seal any cut surfaces on wooden
worktops with a special varnish,
silicone sealant or resin to prevent the
wood from swelling as a result of
moisture ingress. The sealant must
be heat-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
 Position the spring clamps  and the
spacer bars  at the top edge of the
cut-out in the positions shown in the
illustrations.
 Secure the spring clamps  and
spacer bars  with the 3.5 x 25 mm
wood screws supplied.
Installation
41