Respekta CH 0150 IXB Installation & User's Instructions page 31

English
18. General INSTALLATION INSTRUCTIONS
Comply with safety distance between hob and hood.
13.
Remove the hood from the bracker
14.
Drill two 8mm holes for the hood locking screws at the marked points on the wall.
B3
B10
15.
Hang the cooker hood on the suspension plate B3
through the 2 holes B15
16.
Fix
the exhaust hose B12 on the nozzle 10
according to B13 or B14.
17.
Slide the chimney shafts B6 & B8
carefully, that the external (lower) chimney shaft hangs on the mounting bracket B4
picture B5.
18.
Slide the internal chimney shaft B8 up and fix it on the mounting bracket B7
described in picture B9.
Depending on the specific situation the assembly procedure might proceed differently.
MOUNTING OF THE V-FLAP
If the cooker hood does not have an assembled V-flap 1, you should mount the halfparts
to its body.The images only show an example of how to mount the V-flap,
because the outlet may vary according to different models and configurations.
To mount the V-flap 1 you should:
• Mount two half-parts 2 into the body B10
• the pin 3 should be top oriented;
• the axis 4 should be inserted into the holes 5 on the
body;
• repeat all the operations for the 2nd half-part.
fi1912105TNM
Installation- & User's Instruction
B3 and put it aside.
B8
B6
B15
on the wall, so that the hood can not accidentally be removed from the wall.
and to its final position at the other end of the hose
one inside the other and put them on the cooker hood. Then check
(See chapter 11.1)
B7
B4
B12
again and secure it well by fixing the screws
B10
13
Some Figures are for illustration purposes only
Chimney cooker hoods
B9
B5
B9
as described in
with 2 screws as
2
4 3
5 1
GB
B13
B14