•
Press
/ repeatedly to select the entry
location;
•
To enter the desired digits, use the
alphanumeric buttons on the remote
control; or press / repeatedly.
Note
•
Ensure that you never enter an IP address that
is already assigned to a computer/device on
the network.
Wired connection
Connect to the router by using the Ethernet
cable
1
Select [Yes], when asked whether to set
up network connection (see 'First-time
setup' on page 28).
2
Use an Ethernet cable to connect the unit
to the router.
Connect to the home Wi-Fi/wired network
•
MCi900
•
On the unit, select
[Wired (Ethernet)].
The unit starts to acquire an IP address
»
assigned by the network automatically.
A message appears when the
»
connection is completed successfully.
2/2
i
Wireless (W
Wired (Ethernet)
Tip
The router may fail to assign an IP address,
if the DHCP (Dynamic Host Configuration
Protocol) is unavailable or disabled on the
router. You may need to enter the IP address
manually, or press BACK to start re-
connecting.
12V=1A
To Mode m
LAN4
LAN3
LAN2
LAN1
Reset
i
F
)
EN
33