VisualSonics Vevo 3100 Getting Started Manual page 22

Electric Shock
Warning: Before connecting the Vevo 3100 Imaging System to the mains,
verify that the specified voltage on the safety label matches the power
source voltage and that the mains cable is undamaged. Do not connect the
system's power supply to an MPSO or extension cord. An incorrect power
source voltage or damaged cable could cause an electrical hazard and could
cause serious damage to the equipment.
Warning: Do not remove any panels from the Vevo 3100 Imaging System.
Do not remove the outer transducer housing. Any internal adjustments,
replacements or modifications to the system electronics or to the
transducers, should be made only by qualified FUJIFILM VisualSonics
Technical Support Representatives.
Warning: Protection against electrical shock has been provided through an
isolation transformer and chassis grounding via a plug to an appropriate
power source. DO NOT remove the ground wires from any part of the Vevo
3100 Imaging System. Ensure that all power sources, whether a UPC or a
wall outlet, are properly grounded or earthed. If the system is not properly
grounded or earthed, it becomes a possible electrical shock hazard.
Warning: Connection of equipment not authorized by
FUJIFILM VisualSonics to the Vevo 3100 Imaging System isolation
transformer could result in an electrical hazard.
Warning: Do not immerse the transducer in coupling medium beyond the
lowest ring on the transducer housing. The housing of the transducer is not
watertight. If the transducer is immersed beyond the lowest ring on the
transducer housing, the electrical safety features may be compromised.
Warning: Disconnect the system from the power source before cleaning the
system or performing any maintenance operations. DO NOT spray cleaners
or disinfectant directly on the system surfaces. Doing so may cause solution
to leak into the system, damaging the system and voiding the warranty.
- 22 -