Panasonic ZEQUO 5410DL Installation Manual page 4

Do not connect any other devices except for 100BASE-TX/1000BASE-T/10GBASE-T

devices to the twisted pair ports.
Deviation could lead to equipment failure.
Do not insert any other modules except for our optional SFP module

(PN54021K/PN54023K) and the SFP+ module (PN59021/PN59023) to the SFP+
extension slots.
Do not insert any other modules except for our optional SFP module

(PN54021K/PN54023K), SFP+ module (PN59021/PN59023), or SFP+ direct-attach
cable (OPSFPP-T01/OPSFPP-T05) to the stacking ports (Port15-16).
Check out our website for the latest information on supported SFP modules.
Do not connect the console ports with any other console cables except for our

optional PN72001 RJ45-DSub 9-pin console cable.
Deviation could lead to fire, electrical shock, and/or equipment failure.
 Use the bundled power cord (AC 100 – 240 V specifications).
Deviation could lead to electric shock, malfunction, and/or equipment failure.
 Unplug the power cord in case of equipment failure.
Deviation, such as keep connecting for a long time, could lead to fire.
Be sure to connect the ground cable.

Otherwise this might cause electrical shocks, misoperations and malfunctions.
Connect the Ethernet Switch via the supplied power cord to the outlet which is
connected to the ground.
If the outlet is not connected to a ground, connect the ground cable to the ground
terminal screw.
 Connect the power cord firmly to the power port.
Deviation could lead to electric fire, shock, and/or malfunction.
 If the STATUS LED is blinking in orange (systemt fault), check for the cause
via the system log, since it might be a malfunction if it is not the temperature,
loop detection and shutoff, unplug the power plug.
Deviation, such as keep connecting for a long time, could lead to fire.
Handle the Ethernet Switch carefully to prevent fingers and hands from being

damaged by twisted pair port, SFP extension slot, stacking port, console port,
SD card slot, or power cord hook block.
When connecting 10GBASE-T (IEEE 802.3an) supported devices to this device,

use Cat6 or above cables.
If any other cables except for the aforementioned are used, malfunctions might be
caused.
 Check whether the optical fiber cable connectors are contaminated with dust, etc.
This might cause the optical signal to not be transmitted normally, and cause
misoperations and malfunctions. If they are contaminated, make sure to clean
them off, then connect them to the optical fiber ports.
4
CAUTION