Assembly - HAMPTON BAY LILLYCREST II Use And Care Manual

Assembly - Hanging the Fan (continued)
3
Making the electrical connections
WARNING: Each wire nut supplied with this fan is designed to
accept up to one 12-gauge house wire and two wires from the
fan. If you have larger than 12-gauge house wiring or more
than one house wire to connect to the fan wiring, consult an
electrician for the proper size wire nuts to use.
WARNING: Remove the rubber motor stops on the bottom of
the fan before installing the blades or testing the motor.
IMPORTANT: Use the plastic wire connectors (BB) supplied with
your fan. Secure the connectors with electrical tape and ensure
there are no loose strands or connections.
NOTE: The fan comes with 54 in. lead wires for use with an
extended ball/downrod assembly. If using the 4.5 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your desired
length (no shorter than 12 in.).
□
The fan comes with 54 in. lead wires for use with an extended
ball/downrod assembly. If using the 4.5 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your
desired length (no shorter than 12 in.) This will make extra
room in the canopy (C), if you do not wish to cut the wires, you
will need to neatly wrap them.
4
Wrapping the extra wire
NOTE: Follow this step ONLY if you did not cut the extra length from
the wires coming from the ceiling fan.
□
Gently wrap the excess wire around the mounting bracket (A).
□
Secure the wires with electrical tape.
Please refer to remote installation
instructions at the beginning of
this manual.
9
Please contact 1-855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM