Operation; Cleaning, Care And Maintenance - Polar Electro GH218-A Instruction Manual

Display glass door fridge
Table of Contents

Advertisement

Telephone Helpline: 1300225960

Operation

Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
Do not place uncovered hot food or liquid
inside the appliance.
Wrap or cover food where possible.
Do not obstruct the fans inside the appliance.
Avoid opening the doors for prolonged periods
of time.
Turn On
1. Close the door(s) of the appliance.
2. Ensure the power switch is set to [O] and turn
on at the socket.
3. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Control Panel
C
A - Power Switch
B - Lamp Switch
C - Controller
To See the Setpoint
Push and immediately release the SET key: the
display will show the Setpoint value.
Changing the Setpoint
1. Push the SET key for more than 2 seconds to
change the Setpoint value.
2. The value of the set point will be displayed and
the COMPRESSOR LED starts blinking.
3. To change the Set value push
buttons within 10 seconds.
4. To store the new Setpoint push the SET key or
wait 10 seconds.
GH218-A_GH219-A_A5_v1_20210816.indb 5
GH218-A_GH219-A_A5_v1_20210816.indb 5
Manual Defrost
The appliance will automatically run a defrost cycle
every six hours.
To manually defrost the appliance:
1. Press and hold the aux button for more then 2
seconds.
2. The defrost cycle will start immediately and the
Defrost LED illuminates.
3. The next automatic defrost will start six hours
after the manual defrost has finished.
Cleaning, Care &
Maintenance
A
B
Clean the interior of the appliance as often as
possible.
Do not use abrasive cleaning agents. These
can leave harmful residues.
Clean the door seal with warm soapy water.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
A POLAR agent or qualified technician must
and
carry out repairs if required.
Note: The cycle starts from the
time the appliance is initially
powered up.
Note: Starting a manual defrost
also resets the automatic
defrost timer.
Defrost appliance at least
every 3 months, more often if
required.
Switch off and disconnect
from the power supply before
cleaning.
AU
AU
5
2021/8/16 10:53
2021/8/16 10:53

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gh219-a

Table of Contents