Pack Contents; Installation; Lock/Unlock The Doors - Polar Electro GH218-A Instruction Manual

Display glass door fridge
Table of Contents

Advertisement

AU

Pack Contents

The following is included:
POLAR Refrigerator or Freezer
Keys
Shelf guides
Shelves
Instruction manual
POLAR prides itself on quality and service, ensuring
that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.

Installation

Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 5cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Set the brakes on the castors to keep the
appliance in position.
4
GH218-A_GH219-A_A5_v1_20210816.indb 4
GH218-A_GH219-A_A5_v1_20210816.indb 4
Telephone Helpline: 1300225960
Removing the Compressor Safety
Band
The compressor is located on the top of the
appliance, and sits on rubber washers. Under
normal operating conditions the compressor is
allowed to vibrate.
To avoid damage through excessive motion
during transit, a stainless steel safety band is
placed over the compressor and screwed into
the top of the appliance.
This safety band and the two screws fixing it
to the appliance must be removed before the
appliance is turned on.

Lock/Unlock the Doors

A lock is fitted to the doors to ensure foodstuffs
are kept secure within your POLAR appliance.
Use the keys provided to lock/unlock the doors.
Fitting the Shelves
1. Place one set of shelf guides on either side of
the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
Compressor
Safety Band
Compressor
Screws
2021/8/16 10:53
2021/8/16 10:53

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gh219-a

Table of Contents