TP-Link Archer C2 User Manual page 11

Chapter 2
4 ) Connect the power adapter to the router and turn on the router.
5 ) Verify that the hardware connection is correct by checking these LEDs.
Note:
If the 2.4G
seconds to turn them on.
2. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
• Method 2: Wirelessly
1 ) Find the SSID (Network Name) and Wireless Password printed on the label at
2 ) Click the network icon of your computer or go to Wi-Fi Settings of your smart
• Method 3: Use the WPS button
Wireless devices that support WPS, including Android phones, tablets and most USB
network cards, can be connected to your router through this method (Not supported
by iOS devices).
Downloaded from ManualsNet.com
Power
On
and 5G Wi-Fi LEDs are off, press and hold the Wi-Fi/WPS button on the rear panel for more than 5
the bottom of the router.
device, and then select the SSID to join the network.
Computer
Computer
Connections are available
Wireless Network Connection
TP-Link_XXXX
TP-Link_XXXX_5G
Connect automatically
search engine
Internet
2.4G 5G
On On
Ethernet cable
< Settings
Wi-Fi
OR CHOOSE A NETWORK...
TP-Link_XXXX
Connect
TP-Link_XXXX_5G
Other...
Connect to the Internet
On
Smart Device
Smart Device
Wi-Fi
8