Sharp SJ-FS810V-WH Service Manual page 45

9) Bundle harness by insulating (vinyl) tape, L-band c and fix at I-grill.
*Fix L-band c same as below picture but don't roll.
*Don't pull harness of Ice cube heater by more than 2 kgf.
(1)Bundle protect tube covering Thermistor and Ice cube heater by fix at I-grill.
*Cover edge of protect tube (Ice cube tray at side) with Ice heater cover t.
(Don't pull harness strongly)
*Line edge surfaces of protect tubes and bind at left side of marking of Ice cube heater as below picture.
(about 55mm between edge surface of protect tube and center of L-band c)
(2)Roll up the insulating (vinyl) tape twice and more on the thermistor harness and Ice cube heater harness.
Bundle harnesses of Ice maker ass'y , Thermistor and Ice cube heater and fix them at I-grill.
*Don't be too loose harnesses of Thermistor and Ice cube heater.
(3)Three harness is bundled in a nylon band.
Thermistor harness
Ice cube heater harness
Insulating (vinyl) tape
[Color : black ,
width : 38mm or 50mm ,
length : 100mm]
20±5mm 100±5mm
L-band C
10) Fix Harness cover at I-grill by tapping screw.
*Don't nip harness of Ice maker ass'y.
claw Connector housing
JST:YLP-06V
into No.3
into No.6
claw
L-band c
(2)
Insulating (vinyl) tape
protect tube must be coverd with Ice heater cover
claw
opposite direction
Soket contact
JST:SYF-01T-P0.5A
L-band c
(1)
55±5
heater's marking
Nylon band
Screw
Harness cover
45
SJFS810VWH
hole No.3
hole No.6
I-grill
(3)
Nylon band
25±5mm