Sharp SJ-FS810V-WH Service Manual page 43

3) Cover Ice cube tray at with Ice heater cover t , and fix 2 point by tapping screw.
*Set Ice heater cover t so as to "
*Tightening toruque is 0.5N m.
4) Put rib of Ice senser in groove of ice maker ass'y.
*Put head of Ice senser points final gear of Ice maker ass'y.
Fix Ice senser to Ice maker ass'y by tapping screw.
*Use jig to prevent variability fixing Ice senser.
*Fix Ice senser but remove allowance between Ice senser and Ice maker ass'y.
*Tightning torque is 0.5N m.
5) Put Ice cube maker to final gear of Ice maker ass'y.
Rollup the insulating (vinyl) tape twice and more on the harness.
*Set Ice cube maker correct direction asbelow picture.
*Put certainly Ice cube maker to final gear.
Ice cube maker
" marking side is on axis of Ice cube tray at.
Ice heater cover t
Screw
Ice maker ass'y
final gear
move this direction
(remove backlash)
Insulating
(vinyl) tape
Harness
Ice maker ass'y
marking "
axis
Ice cube tray at
Ice senser
rib
groove
Ice maker ass'y
Screw
Ice maker ass'y
20± 5mm 70 ± 5mm
43
SJFS810VWH
"
head
Insulating (vinyl) tape
[Color : black ,
width : 50mm ,
length : 70mm]
Harness