Interacoustics Affinity Compact Instructions For Use Manual page 50

D-0123672-H – 2022/05
Affinity Compact - Instructions for Use - US
Normal and reversed coordinate system buttons enable you to
toggle between reversed and normal graph.
Show curser on graph provides inf ormation about each specif ic
measured point in the curve. The curser is "locked" to the curve
and a f requency and intensity label will be displayed at the curser's
position, as illustrated below:
Stimulus Selection allows f or selecting a test stimulus. The
dropdown is only present f or custom made test protocols. The
standards (e.g. ANSI and IEC) have f ixed stimuli.
Monitor: If you wish to listen to the amplif ied stimulus through a
monitor.
1. Connect a monitor headset to the monitor output on the
hardware.
2. Tick the Monitor check box.
3. Use the slider to turn the sound level up and down.
Current Protocol is listed in the lower lef t-hand corner.
The indicates the test is a part of an automatic test f low (Auto
Run). When pressing START all tests with the tick mark will be
perf ormed.
using the mouse by clicking on it. Then right
click at select Run this test.
Upon perf orming a test, the system automatically jumps to the next
one in the test f low.
Colour indication shows the colour selected f or each curve.
Test protocols can be created and adjusted in the HIT440 Setup.
Start/Stop button initiates and ends all tests.
Note that af ter pressing START the text on the button will
change to STOP.
If you wish to perf orm one test only, mark it
indicates that a curve has been measured.
Page 46