Raider Power Tools RD-GG02 Original Instruction Manual page 13

IMPORTANT !!!
The engine is not loaded with fuel. The engine is a four stroke!!! Do not add oil to petrol !!!
Pour fresh unleaded gasoline in the tank by using the funnel or tube with a suitable plug
(not included in the fittings of the machine).
Do not use stayed fuels.
Use the output DC.
Only used for battery charging 12V.
Using a charging cable to connect the battery output DC. The cables must be connected to
the battery as follows: connect the red cable to the positive (+) terminal and the black to the
negative (-) terminal of the battery.
Do not change this way of connection, to avoid damage to the generator or battery
Connect the cables to the battery first and then to the generator.
Remove the cables from the generator first and then from the battery.
Do not attempt to start the car while the generator is connected to the car battery, as this
could damage the generator.
DC output can be used simultaneously with the output AC.
Overload of the right current circuit, automatic fuse will switch off / will go out /. If this
happens wait a few minutes before press it to reset the circuit.
3.2. Stop the engine.
Before you stop the electric, leave it for a short time to work without load to allow the unit
to cool down.
1. In case that the generator is connected to a circuit, you must insert the key in position
"OFF" (switch labeled "CIRCUIT BREAKER")
2. Then disconnect the mechanical circuit of plug.
3. Place the ignition switch contact in "OFF" position.
4. Place the choke plate as shown on the label for final stop of the engine.
Attention! Electric generator is equipped with overload protection.
NOTE! Your generator is equipped with a tap for fuel to interrupt the supply DIRECTLY FROM
FUEL TANK TO WORK SYSTEM (located to the right of the choke valve with LABEL "FUEL").
WNEN TRANSPORTING THE GENERATOR turn the tap in possition "OFF".
CAUTION!
IMMEDIATELY BEFORE WORK place lever valve in position "ON" to ensure
Fueling ENGINE !!!
4. Cleaning, maintenance and storage.
4.1. Keep safety equipment, air slots and the motor housing contaminated by dust and dirt as
possible.
4.2. Clean the unit with a clean cloth or with compressed air at low pressure.
4.3. We recommend that you clean the unit after each use.
4.4. Periodically check the condition of the air filter, which is made of foam rubber and is
cleaned by washing with water.
4.5. Periodically check the oil level in the generator system.
4.6. The generator must be kept clean and dry place, should be prepared for storage as follows:
- Place the tap of gasoline to "OFF"
- Unscrew and remove the filter cup
- Place the tap to "ON" drain the gasoline from the tank
- Screw the cup back
- Start the engine and let it run until it stops. This will remove the fuel from the carburetor
- Pull the starter handle slowly until you feel the effort. This is the compression point. In this
13