Assembling The Side Shelf; Mounting The Side Shelf; Securingthe Chimney - Pit Boss Pro PB1600PS1 Series Owner's Manual

5. ASSEMBLING THE SIDE SHELF

Parts Required:
1 x Side Shelf (#17)
3 x Tool Hook (#D)
Installation:
• Turn the Side Shelf upside down. On the edge of the Side Shelf with
three holes, install the tool hooks into each hole along the edge. The
tool hooks will secureto the nut that is pre-mounted on the inside.

6. MOUNTING THE SIDE SHELF

Parts Required:
4 x Screw (#A)
4 x Locking Washer (#C)
4 x Washer (#B)
Installation:
• From underneath, fasten the Side Chelf to the side panel of the Main
Barrel using four screws,locking washers, and washers.
NOTE:Do not tighten screws completely until all screws have been
installed. Once all screwsare installed, then tighten securely.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not
covered by warranty.

7. SECURINGTHE CHIMNEY

Parts Required:
1 x Chimney Gasket (#7)
1 x Chimney Cap (#8)
1 x Chimney Stack (#9)
2 x Screw (#A)
2 x Locking Washer (#C)
2 x Washer (#B)
Installation:
• Locate the chimney opening on the side of the Main Barrel. From the
outside, secure the Chimney Stack and Chimney Gasket to the side
panel using two screws,locking washers, and washers. The screw will
fasten to the pre-mounted nut on the inside of the barrel.
• Next, secure the Chimney Cap onto the top of the Chimney Stack by
rotating the Chimney Capscrew into the Chimney Stack.
NOTE: Adjust the chimney cap to affect the airflow inside the Main
Grill. If cooking at low temperature, keep the cap more open. Ensure
the chimney cap allows for air to escape.
5
D
D
D
6
7
9
7
17
8
9