Indirect Safety - WAGO 852-112/000-001 Manual

852-112/000-001
• When selecting the location for installation, note that the control cabinet must remain
accessible for maintenance purposes.
• Before startup, please check the product for any damage that may have occurred dur-
ing shipping. Do not put the product into operation in the event of mechanical damage.
• Only use this product in a controlled environment.
• Do not open the product housing.
• Avoid conductive contamination.

2.5 Indirect Safety

• Do not use hard objects that could cause scratches for cleaning.
• Do not use any contact spray for cleaning.
• Clean tools and materials are imperative for handling the product.
• The products are not resistant to materials having seeping and insulating properties
such as aerosols, silicones and triglycerides (found in some hand creams). If these
substances occur in the environment of the products, install the products in an addi-
tional housing that is also resistant to these substances.
• Before installation and operation, please read the product documentation thoroughly
and carefully. In addition, note the information on the product housing and further infor-
mation, e.g. at ü www.wago.com/<item number>.
• Change the password. The factory default setting is widely known and does not pro-
vide adequate protection.
• Give all products in a network different IP addresses.
• Use only the current firmware.
• Regularly perform threat analyses. You can check whether the measures taken meet
your security requirements.
• Use "defense-in-depth" mechanisms in your system's security configuration to restrict
the access to and control of individual products and networks.
Product manual | Version: 1.0.0
Industrial Eco Switch
Safety
11