Montarbo M3A Manual page 9

Important !
Product Care and Maintenance
• Never expose the enclosure to heat sources such as radiators
or other products that produce heat.
• Never expose the enclosure to direct sunlight, excessive
vibrations or mechanical shocks.
• Avoid operating and storing the enclosure in dump or dusty
places: this will avoid malfunctions, premature degrading of
specifications.
• Avoid using the enclosure close to strong sources of
electromagnetic interferences (e.g. video monitors, high
power electrical cabling). This may lead to degradation of
audio quality.
• Care should be taken so that objects do not fall and liquid
are not spilled into the enclosure. In public event don't let
people, musicians, technicians or anyone put glasses, cups,
ashtrays or cigarettes on the enclosure.
• Use a soft brush or a jet of air to clean the enclosure.
Do not use alcohol, solvents or detergents.
• Take care of your connector cables. Make sure that they
are not damaged, knotted or twisted.
• Never apply excessive force to the controls (knobs,
potentiometers).
active, processor controlled, stage monitor
Power supply connection:
• check that mains voltage corresponds to the voltage
indicated on the panel (beside the main socket).
• use the three wire power cord supplied with the enclosure.
• always connect it to a grounded outlet.
Connection to the mixer:
See 'connection example' page 13
If the mixer has balanced outputs:
- use standard balanced XLR connectors.
If the mixer has XLR unbalanced outputs:
- use standard balanced XLR connectors.
Note: in this case, unless you are using a Montarbo mixer,
make sure that the XLR outs on the mixer are unbalanced
to IEC 268 standard: 1 = GND, 2 = HOT, 3 = GND.
M3A
9
ENGLISH