Mission Editor; Mission Report - ExRobotics ExR-2 Operating Manual

For safety reasons, robots cannot be remotely controlled when the operative is using another
application on the control station. A pop-up will appear with a warning. Clicking on the pop-up will
re-enable remote control.
6.3.

Mission Editor

This screen enables planners to construct and edit autonomous missions as described in Section 7.
6.4.

Mission Report

A typical mission report screen is as follows.
The data for a mission is displayed by clicking on the relevant block to the left of the screen.
The gas detector and acoustic analyser values are displayed on the adjacent graphs.
▪
The plan will be green where the values were below the lower alarm level, amber where
▪
they were between the two alarm levels, and red where they were above the upper alarm
level. Section 6.2 describes how to set the alarm levels.
ExRobotics B.V.
ExR-2 Robot
Operating Guide
This document is considered an uncontrolled copy when printed. Always ensure that you print and use a current version.
Copyright 2022 ExRobotics B.V.
Document No.: Owner:
20220412IP1
Version No.: 2 Ian Peerless
Date:
Page 16 of 39
2022-04-30