Load capacity
16 A/250 V (AC-1)
Pairing
①
②
Correct pairing will be confirmed by temporary switching off of the output
③
circuit and the LED will turn on again.
The receiver can be paired with eight different transmitters (remote but-
tons). Pairing with more buttons will remove the first entries made.
Unpairing
To clear the list of transmitters cooperating with the receiver, press the PROG button and hold it
down for at least 10 seconds. Fast flashing of communication LED will indicate that the memory
of the controller has been cleared.
The actual maximum load depends on the na-
ture and design of the receiver.
For more information visit: www.fif.com.pl.
After proper connection, press and hold the PROG but-
ton until the relay will switch on and the communication
LED will go off.
Press the selected button on a remote control or in
a flush-mounted transmitter.
- 4 -