Table of Contents
Advertisement
Symbol
Property or statement
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
eye protection.
WARNING marking concerning Risk
of Hearing Loss. Wear hearing
protection.
WARNING marking concerning Risk
of Respiratory Injury. Wear NIOSH-
approved dust mask/respirator.
WARNING marking concerning Risk
of Explosion.
SaVE THESE INSTRUCTIONS
PROdUCT SPECIFICaTIONS
Maximum Pressing Capacity
Air Pressure Range*
Operating Methods
Air Inlet Size
Ram Stroke
Crusher Diameter
Oil Filter Capacity
Press Head Diameter
Distance Between Uprights
Arbor Plate Dimensions
Mounting Hole Diameter
*
Exceeding maximum air pressure limit may cause
damage/injury.
UNPaCkINg
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible. Note: Two or more able bodied
people will be needed to set up this heavy
piece of equipment.
SKU 65330
20 Tons (40,000 Pounds)
110 PSI to 120 Maximum PSI
Air Operated and Manually Operated
1/4" x 18 NPT
6-1/2"
5-1/8" O.D.
Up to 6" H x 4" Diameter
4-1/2"
16-3/4"
2-1/16" L x 7-1/4" W x 3/4" Thick
1/2" (Qty. 4)
For technical questions, please call 1-800-444-3353.
aSSEmbLy INSTRUCTIONS
Read the ENTIRE ImPORTaNT
SaFETy INFORmaTION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
1.
Attach the two Legs (16) to the Work-
ing Bed (15) using four Bolts (17),
four Flat Washers (18), four Spring
Washers (19), and four Nuts (20).
(See assy. diagram.)
2.
Attach the two Uprights (12) to the
Working Bed (15) using four Bolts
(4), four Flat Washers (3), four Spring
Washers (2) and four Nuts (1). Hand
tighten only. (See assy. diagram.)
3.
Attach the two Screw Hooks (6) to the
Frame (7) using two Flat Washers (8)
and two Nuts (10). Leave the Nuts
untightened to provide easy Springs
attachment. (See assy. diagram.)
4.
Slide the Frame (7) down between
the two Uprights (12) onto the Work-
ing Bed (15). (See assy. diagram.)
5.
Attach the Top Cross Beam (22) to
the two Uprights (12) using four Bolts
(4), four Flat Washers (3), four Spring
Washers (2), and four Nuts (1).
(See assy. diagram.)
6.
Attach one end of the Springs (5) to
the mounting holes on the Top Cross
Beam (22) and the other end of the
Springs to the Screw Hooks (6) on
the Frame (7). (See assy. diagram.)
Page 6
Advertisement
Table of Contents
