Harbor Freight Tools PITTSBURGH 61411 Owner's Manual & Safety Instructions

45 piece titanium nitride sae tap & die set

Owner's Manual & Safety Instructions

Save This Manual

operating, inspection, maintenance and cleaning procedures. Write the product's serial number in the

back of the manual near the assembly diagram (or month and year of purchase if product has no number).

Keep this manual and the receipt in a safe and dry place for future reference.

Email our technical support at: productsupport@harborfreight.com

When unpacking, make sure that the product is intact

and undamaged. If any parts are missing or broken,

please call 1-888-866-5797 as soon as possible.

2020 by Harbor Freight Tools

No portion of this manual or any artwork contained herein may be reproduced in

any shape or form without the express written consent of Harbor Freight Tools.

Diagrams within this manual may not be drawn proportionally. Due to continuing

improvements, actual product may differ slightly from the product described herein.

Tools required for assembly and service may not be included.

Keep this manual for the safety warnings and precautions, assembly,

Visit our website at: http://www.harborfreight.com

Read this material before using this product.

Failure to do so can result in serious injury.

SAVE THIS MANUAL.

20h

Table of Contents

Need help?

Do you have a question about the PITTSBURGH 61411 and is the answer not in the manual?

Page 1 No portion of this manual or any artwork contained herein may be reproduced in Failure to do so can result in serious injury. any shape or form without the express written consent of Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing SAVE THIS MANUAL.
Page 2 Important Safety Information Wear ANSI-approved safety goggles and 10. Do not use any high-speed means, such as a heavy-duty work gloves during use. lathe or drill press, to cut threads with these Taps and Dies. High-speed use will void the Keep bystanders out of the area during use.
Page 3 Die Instructions DIES are used to cut (threading) or clean (chase) external threads, such as on a screw or threaded rod. NOTE: It will be easier to start the Die correctly Align the groove on the side of the if the end of the work material is slightly Die with the Screw on the Die Holder.
Page 4 Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.