Leveling The Washing Machine - Kenmore 796.5197 Series Use & Care Manual

LEVELING THE WASHING MACHINE

The washer tub of your new washing machine spins at very
high speeds. To minimize vibration, noise, and unwanted
movement, the fl oor must be perfectly level and solid.
• Check that the washing machine is level.
- Check for levelness by rocking the top edges of the
washing machine or placing a level on the washing
machine. The slope beneath the washing machine
must not exceed 1/2", and all four leveling feet must
rest fi rmly on the fl oor.
• Turn the lower leveling feet clockwise to level the
washing machine.
- Turning the lower leveling feet clockwise raises the
washing machine.
• Turn the locknuts counterclockwise and tighten them
when the washing machine is level.
• Check again that the washing machine is level.
- Push or rock the top edges of the washing machine
gently to make sure that the washing machine does
not rock.
- If the washing machine rocks, adjust feet again.
Level
1/2"
Raise
Tighten all 4 lock
nuts securely using
the wrench.
INSTALLATION INSTRUCTIONS
WARNING:
• Using the washing machine without leveling may cause it
to malfunction, producing excess vibration and noise.
• When stacking the full-size washing machine on the
pedestal washer, use the leveling feet on the pedestal
washer to level both. The full-size washing machine´s
leveling feet should be minimized and the locknuts turned
counterclockwise to secure them.
• Use the leveling feet only when you level the washing
machine. If you raise the leveling feet unnecessarily, it
may cause abnormal vibration of the washing machine.
USING NON-SKID PADS (OPTIONAL)
If you install the washing machine on a slippery surface,
it may move because of excessive vibration. Incorrect
leveling may cause malfunction through noise and
vibration. If this occurs, lay the non-skid pads under the
leveling feet and adjust the level.
• Clean the fl oor to attach the non-skid pads.
- Use a dry rag to remove foreign objects or moisture.
If moisture remains, the non-skid pads may slip.
• Adjust the level after placing the washing machine in
the installation area.
• Place the adhesive side of the non-skid pad on the
fl oor.
- It is most eff ective to install the non-skid pads under
the front legs. If it is hard to place the pads under
the front legs, place them under the back legs.
This side up
Remove
backing
• Check again that the washing machine is level.
- Push or rock the top edges of the washing machine
gently to make sure that the washing machine does
not rock. If the washing machine rocks, level the
washing machine again.
13
Adhesive
side