Panasonic KX-HCM280A Operating Instructions Manual page 42

Operating Instructions
• Checking [Yes] for [Allow Access from the Internet] on [Automatic Setup]
may not display the Top page, because the port number may change. Use
the Setup Program to access the camera.
• If the camera is restarted, all buffered images on the internal memory are
deleted.
Setting
Allow Access from
the Internet
(Automatic Setup
Only)
Network
Configuration from
Setup Program
(Static/DHCP Only)
Port Number
(Static/DHCP Only)
• IP address
• Subnet Mask
(Static Only)
42
• Allow Access from the Internet setting automatically
configures the router's Port Forwarding setting (some
routers call it "Address Translation", "Static IP
Masquerade", "Virtual Server" or "Port Mapping"). To
enable Internet access to the camera, check [Yes]. In this
case, the camera automatically searches the unused port
number on your network in the order from 50000 to 50050.
To disable Internet access to the camera, check [No].
• If you prohibit the Setup Program from changing the
network settings, clear the check box.
• The port number is 80 by default. When you use multiple
cameras with a router on your network, each camera must
be assigned its own port number (see page 26 "1.10
Connecting the Camera to a Router Not Supporting
UPnP™ (IPv4 Only)" in the Installation/Troubleshooting).
• Do not set the following port numbers.
E.g., FTP: 20 and 21, Telnet: 23, SMTP: 25, DNS: 53,
POP3: 110, HTTPS: 443, ICQ: 4000 and IRC: 6661—
6667.
• Enter only the number (1—65535).
• Some ISPs do not allow you to use port 80. Ask your ISP
or network administrator about the accessible port number
over the Internet.
• If your ISP or network administrator specifies the IP
address and subnet mask, enter them in each data field.
• If you use the camera on the LAN, set the IP address in the
same class as your PC (see page 131).
• Set 4 digits (0—255) and 3 periods such as
"192.168.0.253". But "0.0.0.0" and "255.255.255.255" are
not available.
Description