Transmission Signal Selection Setting - Panasonic AW-PH360N Operating Instructions Manual

Installation

$ Transmission signal selection setting

The switches on the COMP and CONNECTOR printed circuit boards must be set to
correspond to the signals to be transmitted and components to be connected to the
pan/tilt head.
(When shipped, the analog settings are supported.)
O Analog/IEEE1394 card settings
SDI/PR switch:
WEB/1394 switch:
WEB/RP 422 switch: RP 422
O SDI settings
SDI/PR switch:
WEB/1394 switch:
WEB/RP 422 switch: RP 422
<Note>
OBefore setting the switches, make absolutely sure that the power of the AC adapter
which is to be connected to the pan/tilt head is set to OFF.
(The installation work must be performed by your dealer without fail.)
PR
1394
SDI
1394
COMP printed circuit board
CONNECTOR printed circuit board
O WEB card settings
SDI/PR switch:
WEB/1394 switch:
WEB/RP 422 switch: WEB
- 11 -
PR
WEB
COMP switch
SDI/PR switch
PB switch
Do not change the setting of this
switch — use it at the PB position.
WEB/1394 switch
WEB/RP 422 switch