Panasonic AW-PH360N Operating Instructions Manual page 8

Parts and their functions
1 Tilting arm
This tilts in the vertical direction.
2 Tilting arm fixing screws
M4!12 mm (4 screws supplied)
3 Camera mounting plate
This is used to mount the convertible
camera.
4 Guide screws
These are used to maintain the
camera's balance and anchor the
camera mounting plate.
5 Guide pin
This determines the mounting direction
of the camera.
6 Guide roller
This serves as the fulcrum for
maintaining the camera's balance.
7 Camera mounting screws
(U1/4˝-20 UNC)
These are used to mount the camera
and anchor it securely.
8 Head
This rotates in the horizontal direction.
9 Tally lamps (!2)
These light (red) in response to the
selection signals.
: Head connector panel
This is used for connection with the
camera and lens.
; Base
< Pan/tilt head mounting holes
These four holes are used for mounting
the pan/tilt head.
= Safety wire mounting hole
This is used when attaching a wire to
prevent the pan/tilt head from dropping.
> Base connector rear panel
This is used for connection with a
controller, multi-port hub or AC adapter
for the pan/tilt head.
? Base connector front panel
This is used for connection with a
camera control or a personal computer.
- 8 -