Table of Contents
Advertisement
2. Prepare the Site
3''
(76 mm)
Min
Drip Loop
IMPORTANT! The power supply must be installed within the stud framing, near the valve. Verify that the power supply
is installed above the valve and below the electrical outlet.
NOTICE: Do not install the valve in any location where the temperature may exceed 122°F (50°C).
NOTICE: This product can be mounted on a rigid backer board or telescopic brackets (not supplied).
NOTE: Horizontal installation within a stud cavity is shown. The valve can also be mounted vertically or mounted to a
horizontal surface. Refer to the "Mounting Configurations" section.
NOTE: This product is designed to fit within a minimum 14-1/2" (368 mm) stud cavity. Verify that there is a minimum 3"
(76 mm) depth clearance.
Install a 230 V RCD electrical outlet within the stud framing, near the valve. Locate the electrical outlet above the valve
and power supply.
1430528-W2-A
Board Mount
Drip Loop
14-1/2''
(368 mm)
14
3''
(76 mm)
Min
Drip Loop
Bracket Mount
Drip Loop
14-1/2''
(368 mm)
Kohler Co.
Advertisement
Table of Contents
