Prepare The Site - Kohler K-682 Installation Manual

21" (53.3 cm) Min
6" (15.2 cm)
20-3/16"
(51.3 cm)

8. Prepare the Site

NOTE: Vertical wall installation shown. The valve can also be wall-mounted horizontally or mounted to a
horizontal surface. Refer to the "Valve Mounting Configurations" section.
This product is designed to fit within a minimum 21" (53.3 cm) 2x4 stud cavity. If necessary to
modify the stud cavity, apply adequate bracing for mounting the valve.
9. Install the Electrical Outlet
CAUTION: Risk of product damage. The power supply is rated to operate in temperatures up to
104°F (40°C). Do not install the power supply under a whirlpool surround or in any location where the
temperature may reach temperatures over 104°F (40°C).
Install a 120 V GFCI electrical outlet, within the stud framing, in close proximity to the valve. Locate
the outlet above the valve allowing ample space to mount the power supply in close proximity to
the outlet.
Kohler Co.
Power Supply
1-1/4" (3.2 cm)
Place outlet and
power supply higher
than electronic valve.
Outlet
Install bracing.
Drip Loop
13
Screws
Valve
Drip Loop
1043183-2-B