Table of Contents
Advertisement
OTHER RECORDING FUNCTIONS
IMPORTANT!
• Any one of the following conditions can reduce the
range for remote controller operations.
— When the card remote controller signal emitter is
at an angle to the camera's signal receiver
— When the camera is exposed to bright light
— When the card remote controller battery is low
• Unlike the camera's shutter button, you cannot press
the remote controller shutter button half way.
Pressing the remote controller shutter button causes
the camera to perform an auto focus operation and
then record the image.
• Contrast type Auto Focus, which allows Auto
Focusing capabilities even if the phase differential
sensor is blocked
• When performing a high-speed continuous shutter
mode operation with the card remote controller, keep
the shutter button of the card remote controller
depressed until all of the images (up to five) are
recorded. If you want to stop recording part way
through, release the shutter button.
• A continuous shutter or auto bracketing record
operation may be interrupted part way through if
remote control signal reception is interfered with or if
the card remote controller battery goes low.
• When using the card remote controller for "BULB"
recording (pages 95, 96), press the card remote
controller shutter button once to start exposure, and
a second time to stop exposure. This is different from
the operation using the camera's shutter button,
which you must keep depressed as long as you want
exposure to be performed. Note that card remote
controller shutter button operations are different from
camera shutter button operations.
• Installing a conversion lens on the camera can cause
the signal receiver on the front of the camera to
become blocked. Point the card remote controller at
the signal receiver on the side of the camera in this
case (page 153).
148
Advertisement
Table of Contents
