Advertisement
Electric Counter Tilting Skillet
Installation Instructions
Unpacking
Immediately after unpacking, check for possible shipping damage. If the gas fired tilting skillet is found to be damaged,
save the packaging material and contact the carrier within 5 days of delivery.
Before installing, verify that the type of gas supply (natural or propane) and electrical service agree with the
specifications on the rating plate located on the left side console as you face the front of the appliance. If the supply and
equipment requirements do not agree, contact your dealer immediately.
Units equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly
into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug. (120 volt units only).
Installation Instructions
1. Position appliance on counter allowing sufficient rear clearance from wall to tilt freely and completely without
obstruction.
2. Mark four corner locations of appliance base, as shown below.
3. Remove appliance from counter and locate position of four holes as per drawing detailed below. Drill four 7/16" diameter holes.
4. Apply a continuous bead of Silastic or other equivalent sealant along the complete perimeter edge of the appliance base.
5. Use 5/16-18 Hex Cap Screws with suitable flat washers to bolt down. Screw length must be 1-1/4 long plus counter
top thickness.
6. Wipe off excess sealant.
7. A Control Box with power supply equivalent to Electrical Rating of appliance should be located conveniently nearby.
8. A waterproof electrical connection for power supply to console housing must be provided.
9. Ground appliance to terminal provided inside console housing.
10. Turn power ON and check for proper operation.
INSTALLATION & OPERATION MANUAL 10011 REV 5 (11/21)
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
ELECTRICAL GROUNDING INSTRUCTIONS
WARNING
Installation
5
PAGE
OF12
Advertisement
