Error Codes - Panasonic AJ-SPX800 Operating Instructions Manual

5. P2 Card Fully Recorded
Display window All 7 bar indicators for remaining MEDIA capacity
indication start blinking.
Continues to light up until an operation is
WARNING lamp
performed.
Continues to blink 4 times per second until an
Tally lamp
operation is performed.
Viewfinder The END indicator blinks.
Continues
Warning tone
performed.
Warning
The P2 cards are recorded to maximum capacity.
description
Recording/
The recording stops.
playback operation
Delete the clips in the P2 card or insert a new P2
Countermeasures
card.
6. Recording Error
Display window "00:00:00:11" appears in the time code display
indication field.
Blinks 4 times per second while recording
WARNING lamp
continues.
Blinks 4 times per second while recording
Tally lamp
continues.
The REC WARNING indicator lights up.
Even after recording is stopped, this display
Viewfinder
continues to light up until the next operation is
performed.
Beeps 4 times per second while recording
Warning tone
continues.
Warning
Recording signal processing error.
description
Recording/
Recording stops.
playback operation
Restart recording. Or, turn the power OFF and
Countermeasures
turn it ON again, before starting recording.
7. Low Wireless Signal Reception
Display window
No display.
indication
Blinks 4 times per second. (During pause and
WARNING lamp
recording)
Blinks 4 times per second while recording
Tally lamp
continues.
The WIRELESS RF indicator lights up while
Viewfinder
recording continues.
Beeps 4 times per second while recording
Warning tone
continues.
Warning This error indicates poor wireless audio reception
description conditions.
Recording/ Continues to operate without receiving the
playback operation wireless microphone signal.
Check the microphone power supply and the
Countermeasures
reception status of the wireless receiver.
to beep until an operation is
8. Battery Nearly Empty
Display window One of the bars in the battery remaining indicator
indication starts blinking.
WARNING lamp Blinks once per second.
Tally lamp Blinks once per second.
Viewfinder The BATT LED blinks.
Warning tone Beeps 4 times per second.
Warning
The battery is about to run out.
description
Recording/
Continues to operate.
playback operation
Countermeasures Replace the battery as required.
9. P2 Card Nearly Full
Display window One of the bars for remaining MEDIA capacity
indication starts blinking.
Blinks once
WARNING lamp
continues.
Blinks once
Tally lamp
continues.
Viewfinder The P2 card remaining capacity indicator blinks.
Beeps once
Warning tone
continues.
Warning The total remaining capacity of all the P2 cards is
description two minutes or less.
Recording/
Continues to operate.
playback operation
Replace the cards. If there is an empty card slot,
Countermeasures
insert a new card.
7-3-2

Error Codes

The following error codes are displayed in the display window if
an error occurs in the camera:
Code No.
E-11 Video initialisation error
E-27 Recording control error
E-30 P2 card removal error
E-38 P2 streaming microcontroller error
E-3F Microprocessor error in the camera control circuit.
E-6F Reference signal error.
per second while recording
per second while recording
per second while recording
Description
89
7