Starting And Stopping Your Compressor - Turbo Air TA1500 Manual

100L/MIN OIL - LESS COMPRESSOR

STARTING AND STOPPING YOUR COMPRESSOR

NOTE: Always ensure that you plug your compressor into a
standard 240V AC power point. Never use an extension cord
as this can lead to a voltage drop which may cause power
loss and over heating. Use a longer air hose if you need to
get closer to your work area.
Always start and stop the compressor using the
ON/OFF button on the Pressure Switch (Pic. 1 Item 1 and 2 as
well as Pic. 4). Damage caused by not using this button will not
be covered by warranty.
To turn your Compressor
Lift up the red ON / OFF button on top of the pressure switch
To turn your To turn your Compressor OFF;
Push down the red ON / OFF button on top of the pressure
switch
RUNNING IN YOUR NEW COMPRESSOR
Your compressor does not require running in. Before use ensure
you have read and understood these instructions.
Before use ensure this compressor is fully assembled as per
page 10.
Positioning your new compressor
Choose a location away from your work area and near to a mains
power point.
NOTE: 1. Never use an extension lead. Always use a longer
air hose
2. Always position compressor on level ground
3. Always position compressor away from work area so
that the compressor does not get covered in dust or paint -
use a longer air hose to ensure compressor is in clean air
10.
ON;
PIC. 4
Lift button
up for on
Push button
down for off