Table of Contents
Advertisement
DIRECT DRIVE COMPRESSOR
This air compressor requires some minor assemble before it can
be used. Locate the accessory pack. It should contain:
• Wheels and Axle Set
• Rubber Stopper
• Air Filter
• Oil Breather Plug
• A Bottle of Oil
1. Fit the wheels to
the unit using the axle
kit provided and insert
the rubber stopper into the
spigot on the bottom of the tank.
WARNING!
This unit is shipped with oil in the compressor pump. Oil
must be added to the unit prior to operating.
Recommended Compressor Oil:
Use SAE30 for temperatures over 10
NOTE: The oil must be changed after the first 10 hrs of operation
then every 20 hrs thereafter.
ASSEMBLING THE COMPRESSOR
CHECKING / FILLING THE OIL
o
and use SAE10 below 10
2. Fit the air filter to the
cylinder head.
1. Always check the oil
level in the pump before
use. When filling, fill the oil
o
.
from the oil breather hole
until the oil reaches the red
mark on the sight glass.
3. Locate the plastic dust plug
in the oil breather hole and
remove it to expose the oil
breather hole.
2. Check that the small hole
in the top of the breather
pipe is clear and then
insert it into the oil filler
hole.
7.
Advertisement
Table of Contents
