Turbo Air TA1500 Manual page 5

DO NOT ABUSE THE POWER CORD
Never yank or pull on the power cord to disconnect it from
the mains supply socket. Never carry or pull your compressor
by its power cord. Keep the power cord away from heat,
oil, solvents and sharp edges. Regularly check the plug
and cord and if damaged have it replaced by an authorised
service facility.
EXTENSION CORDS AND REELS
This compressor MUST be plugged directly into a 240V AC
wall socket.
This compressor is NOT designed to be run off an extension
cord/lead. If you need extra distance do NOT use an extension
cord, USE A LONGER AIR HOSE.
The use of extension cords may cause power voltage loss
and will result in damage to the motor. This will NOT be
covered under warranty.
SECURE THE WORK PIECE
Whenever possible secure the work piece using clamps or
a vice. It is safer than using your hands or feet and leaves
both hands free to control the tool.
HOT COMPONENTS
Beware many of the components will get hot during use.
Never touch any of the metal pipes, pump or motor as these
may burn.
MAINTAIN YOUR COMPRESSORS WITH CARE
Follow the instructions for use and changing accessories.
Check the compressor power cord periodically and if damaged
have it replaced by an authorised service facility. Keep
handles clean, dry and free from oil and grease. Ensure
that ventilation slots are kept clean and free from dust at
all times. Blocked ventilation slots or air fi lter can cause
overheating and damage to the motor and this will not be
covered under warranty.
DISCONNECT COMPRESSORS
Ensure that the compressor is disconnected from the mains
supply when not in use, before servicing, making
adjustments or when changing any accessories.
100L/MIN OIL - LESS COMPRESSOR
REMOVE ADJUSTING KEYS
AND WRENCHES
Form the habit of always checking to see that any adjusting
keys or wrenches have been removed from the compressor or
attached air tools before operating.
AVOID UNINTENTIONAL STARTING
Ensure that the switch is in the 'OFF' position before
plugging the compressor into the mains power supply.
PROTECT FURNISHINGS
If using the compressor inside your house, protect furnishings
and fl oors with a suitable dust sheet.
FIRE PRECAUTIONS
When using the compressor inside your house or workshop
general fi re precautions should be observed. As a
precaution it is recommended that an expert is consulted on
obtaining and using a suitable fi re extinguisher.
CLEANING YOUR COMPRESSORS
Always disconnect your compressor from the mains power
supply before you commence cleaning. Always ensure that
your compressor has cooled, about one (1) hour, before cleaning
and storing. When cleaning your compressor use only a damp
soft cloth. NEVER use liquid or solvents of any type.
5.