Turbo Air TA1500 Manual page 7

IMPORTANT
ELECTRICAL DATA
This compressor is fi tted with a sealed electrical connection plug that is compatible with the mains power supply for Australia
/ New Zealand and meets the requirements of Australian Standards. This compressor must be connected to a supply voltage
that is equal to that stated on the rating label. If the mains power connection plug or power cord becomes damaged it
must be replaced with a complete assembly that is identical to the original, and this must be replaced by an authorised
service centre. Always follow the Australian / New Zealand requirements for connection to the mains supply. If in doubt
always consult a qualifi ed electrician.
SPECIFIC SAFETY INSTRUCTIONS
Do not use the compressor in areas where there is a
Warning!
risk of explosion or fi re from combustible materials. The
sparks generated from certain tools attached to compressor can
ignite combustible materials as well as fl ammable liquids,
paint, varnish, petrol, fl ammable gases and dust of an
explosive nature. As a precaution it is recommended that
you consult an expert on a suitable fi re extinguisher and its
use.
• Do not attempt to modify the compressor, guards or the supplied
accessories in any way.
• Domestic compressor are designed for intermittent operation.
Ideally a 50% duty cycle. (Meaning. 30 seconds ON motor
pumping and 30 seconds OFF, motor not pumping). When the
motor is pumping the attached air tool can not be used. Only
use the attached air tool while the infl ator is not pumping.
• Stop using the attached tool as soon as the compressor starts
pumping.
• Fully assemble compressor before use.
• Always ensure your compressor is level and stable.
• Never use an extension cord with this infl ator always use a
longer air hose.
• Never connect to a generator which does not produce
suffi cient power, at least 1500W and has pure sine wave
power output.
100L/MIN OIL - LESS COMPRESSOR
• Domestic compressors are not designed for
industrial / commercial applications.
• Domestic compressors are not designed for continuous
running. Always follow duty cycle - 50%.
• Avoid touching the pump area as it can become very hot
and may burn.
• Ensure that the compressor is disconnected from the mains
supply when not in use, before servicing, making
changes and when changing attachments such as air
hoses / tools.
• Always use the correct type of tool for the operation to be
carried out.
• Never use the compressor if any part of the unit is damaged.
Always have the compressor serviced by an authorised
service agent.
• Always wear safety eye, ear and respiratory protection
when operating the Compressor.
• Allow the tank to completely fi ll before using the compressor.
• If the compressor makes an unfamiliar sound or vibrates
excessively, switch the Compressor 'OFF' immediately and
disconnect from the mains power supply. Investigate the
possible cause or consult your authorised service facility.
• Always move the compressor using the handle and wheels.
• Always use the compressor on stable ground.
• This compressor is designed to compress normal air. Never
use to compress any other type (s) of gases.
• Never direct the jet of air or other liquids / gases towards
your body, other persons or animals.
• Never direct the jet of air or other liquids / gases towards
this compressor.
• This compressor is not suitable for pharmaceutical, food or
sanitary purposes.
• This compressor is not to be used to for fi lling scuba or
oxygen air bottles or tanks.
• Always follow the instructions relating to the tools
attached to this compressor.
7.