H3C WX5004 Installation Manual page 13

Figure 5 Rear mounting bracket appearance
(1)
(1) Screw hole for fixing the rear mounting bracket to the rack (use M6 screws)
(2) Heat dissipation hole
Installation procedure
Put on the EAD-preventive wrist strap and check that the rack is sturdy and properly
1.
grounded.
Find the screws that are packaged with the front mounting brackets. Attach the
2.
front mounting brackets to the access controller with the screws (see Figure 6
Figure 6 Install front mounting brackets to both sides of the access controller
Find the bearing screws that are packaged with the rear mounting brackets.
3.
Attach a bearing screw into the proper installation hole on the rear, upper right and
left sides of the access controller respectively (see Figure 7
Figure 7 Install bearing screws into the access controller
(1) Three installation holes for bearing screws (choose one as needed)
(2) Bearing screw
(2)
13
(1)
(2)