Raider RD-EFH08 User Manual page 9

9
This heater is an electrical appliance with class I insulation. It consists mainly of a heater
and a fan driven by an electric motor. This appliance is intended for indoor use indoors
with normal humidity and is not suitable for outdoor use. It is equipped with a thermostatic
thermostat. The thermostat senses the inlet air temperature and controls the room
temperature. The thermostat will turn off the heater in case of overheating to ensure safety.
The fan motor is not controlled by a thermostat, when the thermostat interrupts the heating
element, it stops working, but the motor continues to run.
When you use the heater for the first time, you may notice a slight release of smoke. This
is perfectly normal and stops after a short time. The heating element is made of stainless
steel and is coated with a protective oil during production. Smoke is caused by the oil when
heated.
The use of the heater for activities other than its intended use is not permitted.
3. Switch on and off.
Pay attention to the mains voltage! The mains voltage must correspond to the data indicated
on the nameplate of the appliance. Appliances marked with 230 V can also be supplied with a
voltage of 220 V.
FIG. 1
!!! WARNING: Read the instructions in the safety information section carefully. The
instructions must be followed carefully so that the heater can function safely.
Make sure the power cord is not damaged in any way. If the power cord is damaged, it must
be replaced immediately by the manufacturer, its service agent or only qualified personnel.
Make sure that the electrical characteristics of the socket meet the requirements stated
in the instruction booklet and / or on the rating plate located on the appliance. Place the
appliance in an upright position.
Turn on the heater
Plug the power cord into the outlet.
Set the start switch / turn the knob / to the required position:
Fig.1 - off / fan / Medium capacity / Maximum capacity
Switch off the heater
Turn the trigger switch to position "0".
Thermostat adjustment
The room temperature can be adjusted using the control knob. Once the preset temperature
is reached, the thermostat will automatically switch off the heating elements while the fan
continues to run, thus protecting the appliance from overheating. If the temperature drops
above the preset value, the system will switch on the heating elements again.
Self-healing thermal switch
The device is equipped with a built-in self-healing thermal switch, providing a high level of
safety. The self-adjusting thermal shutdown will automatically turn off the power when the
limit temperature is exceeded.