Maintaining The Products And Updating The Firmware; Cleaning The Products; Replacing The Ear Pads; Updating The Firmware Of The Products - Sennheiser EPOS ADAPT 230 User Manual

22

Maintaining the products and updating the firmware

Maintaining the products and updating the firmware

Cleaning the products

Replacing the ear pads

For hygienic reasons, you should replace the ear pads from time to time. Spare ear pads are available from your EPOS
partner.
1
X Carefully remove the old ear pad from the ear cup.
CAUTION
Liquids can damage the electronics of the product!
Liquids entering the housing of the device can cause a
short circuit and damage the electronics.
X Keep all liquids far away from the product.
X
Do not use any cleansing agents or solvents.
X
Only use a dry cloth to clean the product.
2
X Attach the new ear pad to the ear cup by pressing firmly
around the ear pad.
23 Maintaining the products and updating the firmware

Updating the firmware of the products

To update the installed firmware:
X Install the free of charge EPOS Connect software (see page 10).
Updating the firmware of the headset
USB-A
X Connect the USB cable to your headset and your
computer.
The LED lights up.
2
EPOS Connect x
ADAPT 200 series Bluetooth ® headset
Updating the firmware of the dongle
1 1
USB-C
USB-A
X Plug the dongle into the USB port of your computer.
The LED lights up.
X Start EPOS Connect.
If there is a new firmware available the software will
guide you through the update process.