FlowCon FN.0.3 Installation And Operation Instruction

FlowCon FN.0.3 actuator
INSTALLATION AND OPERATION INSTRUCTION
The actuator type FlowCon FN.0.3 is an elec-
trical actuator supplied with a valve adaptor for
easy installation.
Figure 1
Fitting and
orientation of the actuator
Separate valve adaptor from actuator (figure 2)
by  pressing the green release button and 
turning the top part of the actuator 30° counter
clockwise.  Then remove the top part of the ac-
tuator from the valve adaptor.

Figure 2
 Rotate the black knob on the valve adaptor
counter clockwise (figure 3) so that the valve
adaptor stem and the green indicators are in top
position.  Mount the valve adaptor on the in-
sert (which must already be installed in the valve
body) and finger tighten the connection union.
Do not use additional tools.
Never install the valve adaptor in closed po-
sition as this may damage the insert.
FlowCon FN.0.3 actuator


Denmark
The piping network can now be tested if necessary
by manually adjusting the valve adaptor knob.
WARNING: Do not force the knob in either
direction and never adjust the black knob
on the valve adaptor with a higher torque
than 1 Nm.

Figure 3
 Then place the actuator on the valve adaptor
and turn clockwise 30°, until a "click" is heard.
Please do not mount the actuator more than 90°
from vertical (figure 4).
Max 90º
Figure 4
Dubai USA
- 1 -
ELECTRICAL ACTUATORS


Max 90º
Singapore www.flowcon.com
1B95071 - 04/2016
FlowCon International assumes no responsibility
for mistakes, if any, in any printed material.