To Manually Set Clock; Alarm; To Set Alarm; To Activate / Deactivate Alarm - Oregon Scientific WMH800 User Manual

TO MANUALLy SET CLOCk

. Press and hold MODE.
2. Press / to change setting options. The settings
order is: country, city, display contrast, +/-1 time zone,
12/24 hour format, hour, minute, year, month-day / day-
month, month, day and language.
3. Press MODE to confirm.
NOTE
The language options are English (E), German (D),
French (F), Italian (I) and Spanish (S).
NOTE
If the clock signal is valid, you are unable to
manually set the time.

ALARM

TO SET ALARM

. Press ALARM to enter Alarm mode.
indicates in Alarm mode.
2. Press and hold ALARM to enter settings.
3. Press / to set hour and minute.
4. Press ALARM to confirm.
5. Press MODE to return to clock display.

TO ACTIvATE / DEACTIvATE ALARM

. Press ALARM to enter Alarm mode.
indicates in Alarm mode.
2. Press ALARM repeatedly to activate or deactivate
alarm. indicates alarm is On.
3. Press MODE to confirm and return to clock display.

TO SILENCE ALARM

• Touch SNOOZE / LIG�T to snooze alarm for 8 minutes
OR
• Press any key to turn the alarm off and activate it again
after 24 hours.

DISPLAy CONTRAST

You can adjust the clarity level of the display. Press and hold
MODE until "CONTR" is shown, then select from 0 (lowest)
to 5 (highest) by pressing
of display contrast. Press MODE to confirm.
BACkLIG�T
Touch SNOOZE / LIG�T to activate backlight for 8 seconds
(only when connected to stand).

RESET

Press RESET to return to the default settings.

MOUNTING / PLACING OF UNIT

To mount onto a wall:
Use the hole located at the back of the unit.
TIP
Leave a small gap between the wall and the unit to
prevent unit from heating up. Insufficient ventilation may
distort indoor temperature / humidity readings.
To place on horizontal surface, such as desk:
Align unit with the stand. Place unit downwards and tilt
slightly backwards to allow unit to lean on the stand.
7
/ for your preferred level