Remote Sensor; Sensor Data Transmission; Clock; Manually Set Clock - Oregon Scientific BAR218HG User Manual

LOCATION
Clock / alarm area
Outdoor temperature area

REMOTE SENSOR

The main unit can collect data from up to 5 sensors.
To set up the sensor:
1. Open the battery compartment.
. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 98 ft (30 m) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 5 ft (1.5 m) and which can shield it from
direct sunlight or wet conditions for an accurate reading.
1.5 m (5 ft)
MEANING
Main unit batteries low
Sensor batteries low
5
NOTE Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures
below freezing.

SENSOR DATA TRANSMISSION

To search for a sensor:
Press and hold and MODE at a time.
The sensor reception icon in the remote sensor
area shows the status:
ICON DESCRIPTION
Main unit is searching for sensor(s).
A channel has been found.
The sensor cannot be found.
TIP The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.

CLOCK

MANUALLY SET CLOCK

1. Press and hold MODE.
. Press or to change the settings.
3. Press MODE to confirm.