Standby Mode - Blackmagicdesign Cintel Installation And Operation Manual

Play
Plays the film. The default frame rate is 24 frames per second. You can set the playback
frame rate and 'play reverse' in DaVinci Resolve's film scanner panel.
Step Forward
Advances the film one frame. You can also hold down the 'step forward' button to play
the film forward at slow speed.
Fast Forward
Rapidly advances the film onto the taking spool. The stopping action performs
the same way as rewind for 50, 75 and 100mm spools.
When you hold down your scanner's 'step back' or 'step forward' button, the scanner advances
or reverses playback at 4 frames per second. You can perform the same 'step back' and 'step
forward' transport controls in DaVinci Resolve's film scanner panel by clicking and holding the
buttons with your mouse.

Standby Mode

When inactive, your scanner will enter standby mode to preserve the longevity of the light
source. This happens after 15 minutes when connected via Thunderbolt, or 1.5 minutes when no
software is connected. Your scanner will signal that it is entering standby mode by flashing the
light source green.
Using Your Scanner 24