Other Settings - Hitachi BD-SG100CJ Operating & Installation Instructions Manual

Changing or disabling the operation start/fi nish sounds
A sound is emitted when an operation starts or fi nishes.
Disabling the 10-minute sound
A sound is emitted as a notifi cation about 10 minutes before an operation fnishes.
Reducing wrinkles after the spin cycle or spinning harder
The degree of wrinkles caused by the spin cycle varies depending on the wash load size and type of
laundry.
Before you start the operation, adjust the spin speed according to your situation.
20

Other Settings

1. Press Power button to turn on the power.
2. Hold Wash Dry button for at least 3 seconds.
The setting changes as follows each time the button is held for 3
seconds.
Melody
3. Press Power button to turn off the power.
Turning the power off completes the setting.
1. Press Power button to turn on the power.
2. Hold Start/Pause button for at least 3 seconds.
Sound enabled (default setting)
Beeps twice and 10-minute
warning sound will be heard.
The sound emitted to indicate change will differ depending on the operation
start/fi nish sound setting.
3. Press Start/Pause button to pause.
4. Press Power button to turn off the power.
Turning the power off completes the setting.
When a spin cycle is repeated to correct the concentration of the
laundry, the warning sound is not emitted.
1. Press Power button to turn on the power.
2. Press Wash button to select the program.
3. Press Spin/Dry Level button to change the setting.
■
Low : Use if you are worried about wrinkles caused by the spin cycle.
■
― : Default setting
■
High : Use when spinning seems insuffi cient or when you want to
shorten the drying time.
4. Press Start/Pause button.
The operation starts.
Buzzer No sound
Sound disabled
Beeps three times.