Hitachi BD-SG100CJ Operating & Installation Instructions Manual page 23

Lint fi lter
Drain outlet
Care and Maintenance
Clean the lint fi lter regularly.
A clogged lint fi lter will result in poor detergent fl ow and drainage ("C02").
1. Perform a spin operation before removing the lint fi lter, and make sure
the water has drained.
2. Open the lint fi lter cover.
3. Remove the lint fi lter.
Place a pan underneath to catch any
remaining water.
Turn the lint fi lter knob about 360
degrees counterclockwise.
Slowly pull out the lint fi lter.
4. Remove the lint, and clear the clogged fi lter.
Avoid cleaning the rubber seal, and only
remove lint and other debris. If you clean off
the lubricant on the rubber seal, the lint fi lter
will be harder to turn.
5. Reinsert the lint fi lter.
Protrusion part must be upward.
Insert the lint fi lter fully into the port.
Turn the knob clockwise until it clicks into place.
Protrusion parts
Clean the drain outlet about once per month, or whenever drying
operations are unusually long or "C02" or "C18" appears.
1. Run a spin operation to make sure the water has drained, and
disconnect the drain hose from the drain outlet.
2. Remove lint and other debris from inside the drain hose and drain
outlet.
3. Insert the drain hose into the drain outlet, and run a spin operation to
check whether water drains.
(P.17)
Knob
Pan
Rubber seal
Knob
23