en
2.6
Fluids hazardous to
health
2.7
Transport
2.8
Use of lifting equipment
2.9
Installing/dismantling
8
Residual-current device (RCD)
•
Install a residual-current device (RCD) in accordance with the
regulations of the local energy supply company.
•
If people can come into contact with the device and conductive
fluids, install a residual-current device (RCD).
Hazardous germs form in sewage or in stagnant water. There is a
danger of bacterial infections!
•
Wear protective equipment!
•
Clean and disinfect the product thoroughly after removal!
•
Inform all persons about the pumped fluid and the danger it
poses!
•
Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
•
Always carry the product by the handle!
If lifting equipment (lifting device, crane, chain hoist ...) is used,
observe the following points:
•
Wear a safety helmet according to EN 397!
•
Comply with local regulations on the use of lifting equipment.
•
The technically correct use of the lifting equipment is the oper-
ator's responsibility!
•
Lifting gear
Use legally specified and approved lifting gear.
–
Select lifting gear based on the attachment point.
–
Attach lifting gear to the attachment point according to local
–
regulations.
•
Lifting equipment
Check it functions properly before use!
–
Sufficient bearing capacity.
–
Ensure stability during use.
–
•
Lifting operation
Do not jam the product when lifting and lowering it.
–
Do not exceed the max. permissible bearing capacity!
–
If necessary (e.g. blocked view), assign a second person to
–
coordinate.
No one should stand under suspended loads!
–
Do not move loads over workplaces where persons are
–
present!
•
Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
•
Disconnect device from the mains and secure it against being
switched on again without authorisation.
•
All rotating parts must stop.
Installation and operating instructions • Wilo-Rexa PRO-S • Ed.01/2022-03
Need help?
Do you have a question about the Wilo-Rexa PRO-S and is the answer not in the manual?