Transport; Storage - Wilo -Rexa PRO-S Installation And Operating Instructions Manual

3.2

Transport

Fig. 1: Attachment point
3.3

Storage

Installation and operating instructions • Wilo-Rexa PRO-S • Ed.01/2022-03
• Subsequently notified defects can no longer be asserted.
CAUTION
Soaked packaging may tear!
The product may fall on the ground if unprotected and may be damaged.
Lift wet packaging carefully and replace it immediately!
• Wear protective equipment! Observe the work regulations.
–
Protective gloves: 4X42C (uvex C500 wet)
–
Safety shoes: Protection class S1 (uvex 1 sport S1)
• Carry the pump by the handle!
• Protect the connection cable against water ingress. Do not immerse attached plugs in the
pumped fluid.
• Only remove the outer packaging at the place of utilisation to ensure that the pump is not
damaged during transport.
• Use tear-proof plastic sacks of sufficient size to package the used pump for transport in a
leak-proof manner.
DANGER
Danger due to fluids which are hazardous to health!
Danger of bacterial infection!
• Disinfect the pump after removal!
• Observe the specifications of the work regulations!
WARNING
Risk of injury from sharp edges on the cutting device!
The macerator has extremely sharp edges. In addition, sharp edges can
form on the suction port. There is a danger of cuts!
• Wear protective gloves!
• Do not touch the macerator!
CAUTION
Defective macerator due to objects lying around!
Hard objects can damage the macerator! When setting down, ensure that
no objects come into contact with the macerator.
CAUTION
Total damage due to moisture ingress
The ingress of moisture into the connection cable damages the cable and
the pump! Never immerse the ends of the connection cable in fluid. Seal
them tightly during storage.
• Place the pump upright (vertical) on a firm bearing surface.
• Secure the pump against falling over and slipping!
• Store the pump for a maximum of one year. Consult the customer service before storing
the device for more than one year.
en
11