Table of Contents
Advertisement
Aria-34e
Installation
Digital Key Telephone System
Figure 16. STIB BOARD
There are two(2) jumper pins and one(1) mode selection switch for each port. In normal
operation, these should be set as in the above table. Customer configuration may require
different configurations, these short pin connections of CONN3 (for 1st port) or CONN4 (for 2nd
port) can be set to different operation modes.
4.5.18 ETIB (ELECTRONIC TERMINAL INTERFACE BOARD) INSTALLATION
The ETIB provides 6 ports of analog type electronic key telephone interfaces. The connection
between the ETIB and MDF are performed through RJ11 type line cords.
Note: The ETIB board can be installed in any of the universal slots(slot #4~7).
4-22
Rev 1.3
Aria Communications Pty Ltd.
A.C.N. 090 723 925
Advertisement
Table of Contents
