Encoder; Grounding Brush - Siemens SIMOTICS SD SH 71 315 Series Operating Instructions Manual

Maintenance
9.3 Corrective maintenance
9.3.11

Encoder

Note
Further documents
Observe all the manufacturer's documentations provided with the encoder.
9.3.12

Grounding brush

• Ensure that the micro-switch, if available with grounding brush unit, is connected to the
drive interlock.
• Check the wearing status of the grounding brush regularly and replace it if necessary.
106
1LE7 shaft heights 71 ... 315
Operating Instructions, 04/2022, A5E51689275A-AA