Table of Contents
Advertisement
Danger when incorrectly lifting and transporting
Danger of death, serious injury, or substantial material damage caused by tipping or falling
transported goods. Comply with the following safety instructions:
• All work must be performed with due caution and care.
• Comply with any notes in the shipping papers.
• Carefully comply with all of the handling information and markings on the packages
whenever transporting and putting the equipment into storage according to ISO 780.
• Only use suitable and adequately dimensioned lifting equipment, transport equipment
and industrial trucks.
Danger due to incorrect attachment and lifting
• Ensure that suitable lifting equipment is available.
• Only hoist the goods using the designated hoisting points and/or at marked positions. The
attachment points are not dimensioned for additional loads.
• Use suitable strap guiding or spreading devices.
• If not specified otherwise in the transport data, always transport the motor in the position
associated with its specific type of construction.
Danger due to damaged attachment points
• Carefully check the attachment points provided on the motor, e.g. attachment eyes, lifting
lugs or ring bolts for possible damage. Replace any damaged attachment points.
• Before using, carefully ensure that the attachment points are correctly attached.
Danger when incorrectly transporting the motor suspended from cables or ropes
If you transport the motor suspended from cables or ropes, the cables or ropes can break, e.g.
as a result of damage. Further, if not adequately attached, the motor can swing. This can
result in death, serious injury, or material damage.
• Use additional, suitable lifting equipment for transport and during installation.
• Two cables alone must be able to carry the complete load.
• Prevent the lifting equipment from sliding by appropriately securing it.
• When using 2-cable lifting equipment, ensure that the maximum angle of inclination is ≤
45° according to ISO 3266 (DIN 580).
• Align the eyebolts so that the cables used for lifting are aligned with the planes of the
eyebolts.
1LE7 shaft heights 71 ... 315
Operating Instructions, 04/2022, A5E51689275A-AA
Preparing for use
4.5 Transport and storage
27
Advertisement
Table of Contents
